Thunder Laser Nova 35 80W Settings for Denim

Cutting Settings

Engraving Settings

How to Set Up Denim on the Thunder Laser Nova 35 80W

1. 1Secure your denim flat on the work bed using clamps, magnets, or a honeycomb pin set to prevent movement during the job.
2. 2Set your focus distance accurately — use the auto-focus probe if your machine has one, or measure manually with the focus gauge.
3. 3Ensure your water cooling system is running and the coolant temperature is between 15–25°C before starting the laser.
4. 4Keep a fire extinguisher or spray bottle nearby. Denim is flammable — never leave the machine unattended while cutting this material.
5. 5Enable air assist if available. A steady stream of air at the cut point removes debris, reduces charring, and helps prevent flare-ups.
6. 6Enter the speed, power, and pass count from the settings table above into LightBurn. The table lists both mm/min and mm/s — LightBurn defaults to mm/s, so use the mm/s value unless you have switched units. Use the “Cut” or “Engrave” layer settings panel.
7. 7Run a small test cut or engrave on a scrap piece of denim before committing to your final project piece. Adjust power up or down by 5–10% based on results.

What to Expect When Lasering Denim

Laser cutting denim seals the edges to prevent fraying, which is a significant advantage over traditional cutting methods. Engraving denim creates a faded, distressed look by burning away the surface dye layer to reveal lighter fibers underneath — this technique is widely used for custom jeans and patches. Expect a slight smoky smell during processing. With 80W of CO2 power, this machine cuts thick acrylic, wood, and other non-metals rapidly — usually in a single pass — and holds up to high duty cycles for production runs. Edge quality stays excellent even at speed.

Common Mistakes to Avoid

• ✗Running at full power on the first attempt — always start with a test piece at the recommended settings and adjust incrementally. Going straight to maximum power risks burning through the material or causing fire.
• ✗Over-powering thin or delicate stock — at 80W it is easy to melt acrylic or scorch thin wood. Lower the power and raise the speed for fine work.
• ✗Leaving the machine unattended — denim can smolder or ignite, especially thinner denim or when engraving at higher power settings.
• ✗Engraving over seams or rivets — thick seams change the focus distance and rivets can reflect the laser beam.

Tips for Denim on Laser Machines

• ✓Low power engraving on denim creates a trendy bleached or faded look without cutting through.
• ✓Pin or tape denim flat to the honeycomb bed to prevent movement and wrinkling.
• ✓Test on a scrap piece first -- denim weight and weave vary significantly between brands.
• ✓For patches, cut slightly oversized and fold edges under before sewing.
• ✓Wash denim before lasering to remove sizing chemicals that can affect cut quality.

Frequently Asked Questions

Other Materials for Thunder Laser Nova 35 80W

Denim Settings for Other Machines