Creality Falcon 2 22W Settings for Cork

Cutting Settings

Engraving Settings

How to Set Up Cork on the Creality Falcon 2 22W

1. 1Secure your cork flat on the work bed using clamps, magnets, or a honeycomb pin set to prevent movement during the job.
2. 2Set your focus distance accurately — use the auto-focus probe if your machine has one, or measure manually with the focus gauge.
3. 3Keep a fire extinguisher or spray bottle nearby. Cork is flammable — never leave the machine unattended while cutting this material.
4. 4Enable air assist if available. A steady stream of air at the cut point removes debris, reduces charring, and helps prevent flare-ups.
5. 5Enter the speed, power, and pass count from the settings table above into LightBurn. The table lists both mm/min and mm/s — LightBurn defaults to mm/s, so use the mm/s value unless you have switched units. Use the “Cut” or “Engrave” layer settings panel.
6. 6Run a small test cut or engrave on a scrap piece of cork before committing to your final project piece. Adjust power up or down by 5–10% based on results.

What to Expect When Lasering Cork

Cork cuts very cleanly with a laser, producing minimal charring compared to wood. The natural brown edge color blends well with the cork surface. Engravings appear as a darker shade against the natural cork. Expect a mild, pleasant woody smell during cutting. Cork is one of the easiest materials to laser due to its low density and consistent composition. The 22W output clears the majority of common materials in one to three passes, giving a good balance of speed and detail. Dense hardwoods and thick acrylic still benefit from a slower finishing pass.

Common Mistakes to Avoid

• ✗Running at full power on the first attempt — always start with a test piece at the recommended settings and adjust incrementally. Going straight to maximum power risks burning through the material or causing fire.
• ✗Using the slow speeds you would need on a 5–10W machine — a 22W diode runs noticeably faster, and going too slow at this power causes excess charring and a wider kerf.
• ✗Using too much power, which can cause cork to burn through or ignite. Cork is low-density and cuts easily — start with conservative settings.
• ✗Skipping the focus calibration step — an out-of-focus beam produces wider, less precise cuts and weaker engravings. Re-check focus every time you change material thickness.

Tips for Cork on Laser Machines

• ✓Cork engraves with excellent contrast -- even low power produces visible marks.
• ✓Use light air assist to prevent scorching without blowing lightweight cork pieces.
• ✓Thin cork sheets (under 3mm) are easiest to work with for beginners.
• ✓Apply masking tape to reduce smoke staining around engraved areas.
• ✓Cork coasters are one of the fastest-selling laser craft products at markets.

Frequently Asked Questions

Other Materials for Creality Falcon 2 22W

Cork Settings for Other Machines